Table of Contents
Advertisement
144 Commissioning
</dg_
"Configuration of NTP Client" Page
7.8.1.24
The settings for the NTP service are shown on the "Configuration of NTP Client"
page.
7.8.1.24.1 "NTP Client Configuration" Group
Table 81: WBM "Configuration of NTP Client" Page – "NTP Client Configuration" Group
Parameters
Service enabled
Service Result
Time Server n
Update interval (sec)
Additionally used
(assigned by DHCP)
Click the [Submit] button to apply the changes. The changes are effective
immediately.
7.8.1.24.2 "NTP Single Request" Group
To update the time immediately, irrespective of the update interval, click [Update
Time Now].
Manual
Version 1.2.0, valid from FW Version 03.02.02(14)
750-8215 PFC200; G2; 4ETH CAN USB
Explanation
Enable/disabled time update.
This displays whether time data was accessible and
updated via NTP.
This field is only displayed with the NTP service
enabled.
Time server not
available until now
Time server available The time data was updated.
Enter here the IP addresses of up to 4 time servers.
Time server No. 1 is requested first of all. If no data
is accessible via this server, time server No. 2 is
requested etc.
Specify here the update interval of the time server.
The NTP servers assigned if necessary by DHCP
(or BootP) are displayed. If no NTP server has been
assigned by DHCP (or BootP), "none" is displayed.
WAGO-I/O-SYSTEM 750
The time data was not yet
updated.
Advertisement
Chapters
Table of Contents
Troubleshooting
