Table of Contents
Advertisement
182 Commissioning
7.8.2.4.7 "TCP/IP" > "Default Gateway" Submenu
This submenu contains other submenus with settings for the default gateway.
Table 129: "Networking" > "TCP/IP" > "Default Gateway" Submenu
Menu Item
0. Back to ...
1. Default Gateway 1
2. Default Gateway 2
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.2.4.8 "Default Gateway" > "Default Gateway n" Submenu
This submenu contains the settings for the selected gateway.
Table 130: "Networking" > "TCP/IP" > "Default Gateway" > "Default Gateway n" Submenu
Menu Item
0. Back to ...
1. State
2. Gateway IP Address
3. Gateway Metric
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Manual
Version 1.2.0, valid from FW Version 03.02.02(14)
750-8215 PFC200; G2; 4ETH CAN USB
Explanation
Back to the higher-level menu
Opens a submenu with settings for default gateway
1
In addition to the menu item, the current status of
the gateway is displayed.
Opens a submenu with settings for default gateway
2
In addition to the menu item, the current status of
the gateway is displayed.
Submenu Item / Explanation
Back to the higher-level menu
Set here whether the selected default gateway is to
be used.
0. Back to ... Back to the higher-level menu
1. Disabled
The default gateway is not used.
2. Enabled
The default gateway is used.
Enter the address of the default gateway.
Set here a number as the metric.
The default value for the metric is 20, the lowest
value is 0, the highest value is 4.294.967.295.
WAGO-I/O-SYSTEM 750
Advertisement
Chapters
Table of Contents
Troubleshooting
