Configuration Of Network Services" Page; Telnet" Group; Ftp" Group; Ftps" Group - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

"Configuration of Network Services" Page

7.8.1.23
The settings for various services are shown on the "Configuration of Network
Services" page.
Close any ports and services that you do not need!
Unauthorized persons may gain access to your automation system through open
ports.
To reduce the risk of cyber attacks and, thus, enhance your cyber security, close
all ports and services in the control components (e.g., Port 6626 for WAGO
I/O-CHECK, Port 2455 for CODESYS 2 and Port 11740 for e!COCKPIT) not
required by your application.
Only open ports and services during commissioning and/or configuration.
Besides enabling/disabling the individual services, you can also limit the services
for each particular interface via the firewall on the "General Firewall
Configuration" page.

7.8.1.23.1 "Telnet" Group

Table 74: WBM "Configuration of Network Services" Page – "Telnet" Group
Parameter
Service active
Click the [Submit] button to apply the changes. The change takes effect
immediately.

7.8.1.23.2 "FTP" Group

Table 75: WBM "Configuration of Network Services" Page – "FTP" Group
Parameter
Service active
Click the [Submit] button to apply the changes. The change takes effect
immediately.

7.8.1.23.3 "FTPS" Group

Table 76: WBM "Configuration of Network Services" Page – "FTPS" Group
Parameter
Service active
Click the [Submit] button to apply the changes. The change takes effect
immediately.
Explanation
Enable/disable the Telnet service here.
Explanation
Enable/disable the FTP service here.
Explanation
Enable/disable the FTPS service here.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 141
Manual