Dynamic Routes" Group; Ip Masquerading" Group; Table 51: Wbm "Routing" Page - "Ip-Masquerading" Group - WAGO 750-8215 Manual

118 Commissioning

7.8.1.9.3 "Dynamic Routes" Group

All default gateways received via DHCP are displayed here.
Default gateways configured via DHCP are given the metric value 10, which
means that they are normally used before the statically configured default
gateways.
Each dynamic route has its own area in the display. If no dynamic routes are
received via DHCP, "(no dynamic route)" appears.

7.8.1.9.4 "IP Masquerading" Group

Each entry has its own area in the display.
Table 51: WBM "Routing" Page – "IP-Masquerading" Group
Parameter
Enabled
Interface
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Click the [Add] button to add a new entry. The change takes effect immediately.
Click the [Delete] button to delete an existing entry. The change takes effect
immediately.
An entry is only transferred to the system if "Routing enabled entirely" is enabled
in the "General Routing Configuration" group. This allows you to configure a
default setting that is not applied until the general switch-on.
Manual
Version 1.2.0, valid from FW Version 03.02.02(14)
750-8215 PFC200; G2; 4ETH CAN USB
Explanation
Specify here whether IP masquerading should be
used for the selected network interface.
Disabled IP masquerading is not used.
Enabled IP masquerading is used.
You can select the specified name of a network
interface here. Alternatively, selecting "other" allows
you to specify any network interface name.
WAGO-I/O-SYSTEM 750