Configuration Of General Snmp Parameters" Page; General Snmp Configuration" Group; Table 94: Wbm "Configuration Of General Snmp Parameters" Page - "General - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

"Configuration of General SNMP Parameters" Page

7.8.1.32
The general settings for SNMP are given on the "Configuration of General SNMP
Parameters" page.

7.8.1.32.1 "General SNMP Configuration" Group

Table 94: WBM "Configuration of General SNMP Parameters" Page – "General SNMP Configuration"
Group
Parameter
Service active
Name of device
Description
Physical location
Contact
Click the [Submit] button to apply the changes. The changes only take effect
after restarting the controller. For this purpose, use the WBM reboot function. Do
not shut down the controller too early!
Explanation
Activate/deactivate the SNMP service.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 157
Manual