Add New User Filter" Group; Table 60: Wbm "Configuration Of User Filter" Page - "Add New User Filter - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

7.8.1.12.3 "Add New User Filter" Group

You can enter 10 filters.
You only have to enter values in the fields that are to be set for the filter. At least
one value must be entered, all other fields can remain empty.
Table 60: WBM "Configuration of User Filter" Page – "Add New User Filter" Group
Parameters
Policy
Source IP address
Source netmask
Source port
Destination IP address
Destination subnet mask
Destination port
Protocol
Input interface
To accept the new filter click [Add]. The change is effective immediately.
Explanation
Select here whether the network devices is to be
allowed or excluded by the filter.
Allow The network device is permitted.
Drop The network device is excluded.
Enter here the source IP address for the new filter
entry.
Enter here the source network mask for the new
filter entry.
Enter here the source port address for the new filter
entry.
Enter here the destination IP address for the new
filter entry.
Enter here the destination network mask for the new
filter entry.
Enter the destination port number for the new filter
entry.
Enter here the permitted protocols for the new filter.
TCP The TCP service is permitted.
UDP The UDP service is permitted.
Enter here the permitted interfaces for the new filter.
X1 The X1 interface is permitted.
X2 The X2 interface is permitted.
VPN The VPN interface is permitted.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 125
Manual