User Filter" > "Add New / No (N)" Submenu; Table 139: "Firewall" > "User Filter" > "Add New / No (N)" Submenu - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB
7.8.2.5.7 "User Filter" > "Add New / No (n)" Submenu
In this submenu, you can create, change or delete filter entries.
Table 139: "Firewall" > "User Filter" > "Add New / No (n)" Submenu
Menu Item
0. Back to ...
1. Policy
2. Source IP address
3. Source netmask
4. Source port
5. Destination IP address
6. Destination netmask
7. destination port
8. protocol
9. interface
10. state
11. accept
12. delete
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Submenu Item / Explanation
Back to the higher-level menu
Select here whether the network devices is to be
allowed or excluded by the filter.
0. Back to ... Back to the higher-level menu
1. Allow The network device is permitted.
2. Drop The network device is excluded.
Enter the source IP address.
Enter the source network mask.
Enter the source port number.
Enter the destination IP address.
Enter here the destination netmask.
Enter the destination port number.
Select the permitted protocols.
0. Back to ... Back to the higher-level menu
1. tcp The TCP protocol is permitted.
2. udp The UDP protocol is permitted.
3. tcp & udp Both protocols are permitted.
Select the permitted interfaces.
0. Back to ... Back to the higher-level menu
1. all All interfaces are permitted.
2. VPN The VPN interface is permitted.
3. WAN The WAN interface is permitted.
4. X1 The X1 interface is permitted.
5. X2 The X2 interface is permitted.
Enable or disable the filter.
0. Back to ... Back to the higher-level menu
1. on The filter is enabled.
2. off The filter is disabled.
To apply the changes for the selected filter entry,
choose this menu item.
To delete the selected filter entry, choose this menu
item.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 191
Manual