Port Forwarding" Group; Table 52: Wbm "Routing" Page - "Port Forwarding" Group - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

7.8.1.9.5 "Port Forwarding" Group

Each entry has its own area in the display.
Table 52: WBM "Routing" Page – "Port Forwarding" Group
Parameter
Enabled
Interface
Port
Protocol
Destination Address
Destination Port
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Click the [Add] button to add a new entry. The change takes effect immediately.
Click the [Delete] button to delete an existing entry. The change takes effect
immediately.
An entry is only transferred to the system if "Routing enabled entirely" is enabled
in the "General Routing Configuration" group. This allows you to configure a
default setting that is not applied until the general switch-on.
Explanation
Specify here whether port forwarding should be
used.
Disabled Port forwarding is not used.
Enabled Port forwarding is used.
You can select the specified name of a network
interface here. Alternatively, selecting "other" allows
you to specify any network interface name.
Enter the port here on which the controller receives
network data packets that are to be forwarded.
Here you can select the protocol to be used for the
port forwarding. The options are TCP, UDP or both
protocols.
Specify the network address of the destination
device here. This address replaces the original
destination address of the network data packet.
Specify the port number of the destination device
here. This value replaces the original "Destination
Port" of the network data packet.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 119
Manual