Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB
7.8.2.12.2 "SNMP" > "SNMP v1/v2c Manager Configuration" Submenu
This submenu contains the SNMP v1/v2c Manager settings.
Table 174: "SNMP" > "SNMP v1/v2c Manager Configuration" Submenu
Parameters
0. Back to ...
1. Protocol state
2. Local community name
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
7.8.2.12.3 "SNMP" > "SNMP v1/v2c Trap Receiver Configuration" Submenu
This submenu contains settings for the v1/v2c trap receivers.
Table 175: "SNMP" > "SNMP v1/v2c Trap Receiver Configuration" Submenu
Parameters
0. Back to ...
(n). Trap Receiver (n)
(n + 1). Add new Trap
Receiver
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Submenu Item / Explanation
Back to the higher-level menu
Enable or disable the SNMP v1/v2c protocol.
0. Back to ... Back to the higher-level menu
The SNMP v1/v2c protocol is
1. Enable
enabled.
The SNMP v1/v2c protocol is
2. Disable
disabled.
Specify here the community name for the SNMP
manager configuration (max. 32 characters, no
spaces).
Explanation
Back to the higher-level menu
Opens a submenu with information on the selected
v1/v2c trap receiver to delete the trap receiver
Opens a series of submenus to create a new v1/v2c
trap receiver
You can enter 10 trap receivers.
The following entries/selections are possible:
•
IP address of the new trap receiver
(management station)
•
Community name for the new trap receiver
configuration (max. 32 characters, no spaces)
•
SNMP version via which the traps are sent
(v1/v2c)
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 213
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
