Data Exchange Module; Ssi Transmitter Interface Modules; Table 264: Serial Interface Modules 750-652, 753-652; Table 265: Data Exchange Module 750-654, -654/000-001 - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

Table 264: Serial Interface Modules 750-652, 753-652

Input and Output Process Image
Process
image
size
8 bytes
24 bytes*
48 bytes
*) Factory setting
17.1.5.6

Data Exchange Module

750-654, -654/000-001
The Data Exchange modules have a total of 4 bytes of user data in both the Input
and Output Process Image. The following tables illustrate the Input and Output
Process Image, which has a total of 2 words mapped into each image.
Word alignment is applied.

Table 265: Data Exchange Module 750-654, -654/000-001

Input and Output Process Image
Offset
0
1
17.1.5.7

SSI Transmitter Interface Modules

750-630, and the variations /000-001, -002, -006, -008, -009, -011, -012, -013
The process image of the / 003-000-variants depends on the parameterized
operating mode!
The operating mode of the configurable /003-000 I/O module versions can be
set. Based on the operating mode, the process image of these I/O modules is
then the same as that of the respective version.
The above SSI Transmitter Interface modules have a total of 4 bytes of user data
in the Input Process Image, which has 2 words mapped into the image.
Word alignment is applied.
Byte Designation
Offset
High Byte
0 C1/S1
1 D1
2 D3
3 D5
4 D7
...
11 D21
12 D23
...
23 D45
Byte Designation
High Byte
D1
D3
Version 1.2.0, valid from FW Version 03.02.02(14)
Low Byte
Control/Status byte
C0/S0
C1/S1
D0
D2
D4
D6
Prozess data (6-46 bytes)
D20
D22
D44
Low Byte
D0
D2
Appendix 353
Description
Control/Status byte
C0/S0
Description
Data bytes
Manual