Status Information" Page; Controller Details" Group; Network Details Xn" Group(S); Table 39: Wbm "Status Information" Page - "Controller Details" Group - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

"Status Information" Page

7.8.1.3
The following tables explain the parameters listed on this page:

7.8.1.3.1 "Controller Details" Group

This group displays the properties of the controller.
Table 39: WBM "Status Information" Page – "Controller Details" Group
Parameter
Product Description
Order Number
License Information
Firmware Revision

7.8.1.3.2 "Network Details Xn" Group(s)

This group displays the network and interface properties of the controller.
If the switch is enabled, one group ("Network Details X1/X2") is shown for both
connections.
If the switch is disabled, a separate group ("Network Details X1" / "Network
Details X2") is shown for each connection.
Table 40: WBM "Status Information Page – "Network Details Xn" Group(s)
Parameter
State
Mac Address
IP Address
Subnet Mask
Explanation
Controller identification
Item number of the controller
Notification that the CODESYS runtime system is
available
Firmware status
Explanation
Status of the ETHERNET interface
(enabled/disabled)
MAC address identifies and addresses the controller
Current IP address of the controller and (in brackets)
the reference type (static/bootp/dhcp)
Current subnet mask of the controller
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 107
Manual