Figure 32: "Wago Ethernet Settings" - "Network" Tab - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB
Select the "Network" tab:
6.
Figure 32: "WAGO Ethernet Settings" – "Network" Tab
To assign a fixed address, select "Static configuration" on the "Source" line
7.
under "Input". DHCP is normally activated as the default setting.
In the column "Input" enter the required IP address and, if applicable, the
8.
address of the subnet mask and of the gateway.
9. Click on [Write] to accept the address in the controller. (If necessary,
"WAGO Ethernet Settings" will restart your controller. This action may
require about 30 seconds.)
You can now close "WAGO Ethernet Settings", or make other changes
10.
directly in the Web-based Management system as required. To do this,
click on [Run WBM] at the right in the window.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 93
Manual