Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB
"Configuration of OpenVPN and IPsec" Page
7.8.1.36
The general settings for OpenVPN and IPsec are shown on the "Configuration of
OpenVPN and IPsec" page.
7.8.1.36.1 "OpenVPN" Group
Table 103: WBM "Configuration of OpenVPN and IPsec" Page – "OpenVPN" Group
Parameters
Current State
OpenVPN enabled
openvpn.config
To apply a status change, click the [Submit] button.
To select a file on the controller or PC, click the [Browse] button.
To transfer the selected file from the PC to the controller, click [Start Upload]
button.
To transfer the selected file from the controller to the PC, click [Start Download]
button.
The changes only take effect after restarting the controller. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
7.8.1.36.2 "IPsec" Group
Table 104: WBM "Configuration of OpenVPN and IPsec" Page – "IPsec" Group
Parameters
Current State
IPsec enabled
ipsec.config
ipsec.secrets
To apply a status change, click the [Submit] button.
To select a file on the controller or PC, click the [Browse] button.
To transfer the selected file to the controller, click [Start Upload] button.
Explanation
The current status of the OpenVPN service is
displayed.
stopped
The service is disabled.
running
The service is enabled.
Enable or disable the OpenVPN service.
Select an OpenVPN configuration file to be
transferred from PC to controller or vice versa.
Explanation
The current status of the IPsec service is displayed.
stopped
The service is disabled.
running
The service is enabled.
Enable or disable the IPsec service.
Select an IPsec configuration file to be transferred
from PC to controller or vice versa.
Select an IPsec configuration file to be transferred
from PC to controller.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 163
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
