Wbm User Administration; Figure 34: Entering Authentication - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB
Some pages of the WBM are accessible only for certain users. They are only
displayed if you have logged into the WBM. You can access the login form via
the "Login" link. Pages which cannot be accessed with your current user name
are already grayed out in the navigation. You can nevertheless select the entries
in the navigation bar and are then routed directly to the login form.
As soon as you have logged in, your current user name is displayed in the
header of the WBM. By clicking the "Logout" link you can log out again and then
log in again with a different user name. When using the WBM without logging in,
you are granted "Guest" access rights.
You must be logged into the WBM in order to have write or read access to (most)
parameters. This is checked with every access to the device.
If you have disabled cookies in your web browser, you can continue to use the
WBM as long as you move directly inside it. However, if you fully reload the
website (e.g., with F5), you must log in again since the web browser is then not
able to store the data of your login session.

Figure 34: Entering Authentication

7.8.1.1

WBM User Administration

To allow settings to be made only by a select number of users, limit access to
WBM functions through User Administration.
Change passwords
The standard passwords are documented in these instructions and thus do not
offer adequate protection. Change the passwords to meet your particular needs.
If you do not change these passwords, a warning will appear each time you call
up a website after logging in.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 101
Manual