INVT Goodrive35 Series Operation Manual page 91

Goodrive35 Series Closed-loop Vector Control VFD
Functio
Name
n code
QUICK/JOG
P07.02
function selection
Shifting sequence
selection of
P07.03
QUICK/JOG
commands
Detailed instruction of parameters
4: Download the keypad function parameters to local
address (only for the motor parameter of P02 and
P12 group)
Note: After completing the 1–4 operations, the
parameter will come back to 0 automatically; the
function of upload and download excludes the
factory parameters of P29.
0: No function
1: Jogging. Press QUICK/JOG to begin the jogging
running.
2: Shift the display state by the shifting key. Press
QUICK/JOG to shift the displayed function code
from right to left.
3: Shift between forward rotations and reverse
rotations. Press QUICK/JOG to shift the direction of
the frequency commands. This function is only valid
in the keypad commands channels.
4: Clear UP/DOWN settings. Press QUICK/JOG to
clear the set value of UP/DOWN.
5: Coast to stop. Press QUICK/JOG to coast to stop.
6: Shift the given manner of running commands.
Press QUICK/JOG to shift the given manner of
running commands.
7: Quick commission mode (commission according
to the non-factory parameter)
Note: Press QUICK/JOG to shift between forward
rotation and reverse rotation, the VFD does not
remember the state after shifting during powering
off. The VFD will run in the running direction set
according to parameter P00.13 during next powering
on.
When P07.06=6, set the shifting sequence of
running command channels.
0: Keypad
→communication control
1: Keypad control←→terminals control
2: Keypad control←→communication control
3: Terminals control←→communication control
84
control→terminals
Function parameters
Default Modif
value
1
◎
control
0
○
y