INVT Goodrive35 Series Operation Manual page 185

Goodrive35 Series Closed-loop Vector Control VFD
0
1
2
0
3
1
4
5
P06.00
HDO
.
Output type
.
.
.
29
30
The below table is the option of the four function parameters and selecting the repeated output
terminal function is allowed.
Set
value
0
1
2 Forward running
3 Reverse running
4
5
6
7
8 Frequency arrival
9 Zero-speed running
10 Upper-limit frequency arrival
11 Upper-limit frequency arrival
12 Ready to run
Digital output
Digital switch-on delay time
P06.06
Y
T delay
P06.01
(default value is 0)
HDO
P06.08
T delay
P06.02
(default value is 0)
ROI
P06.10
P06.03
T delay
(default value is 0)
RO2
P06.12
P06.04
T delay
(default value is 0)
0 Invalid
3 In reverse running
Frequency level detection
6
FDT1
9 In zero speed running
Function
12 Ready to run
15 Underload prealarm
Invalid
18 Reach the set counting value
21 Length reached
Running
PROFIBUS communication
24
virtual terminal output
Jogging
VFD fault
FDT1
FDT2
P06.05 output polarity
0
1
-1
0
1
-1
0
Delay
1
-1
0
1
-1
1 In running
4 In jogging
Frequency level detection
7
FDT2
10 Reach upper limit frequency
13 In pre-exciting
16 Simple PLC stage completed
The output terminal has no function.
· 19 Reach specified count value
22 Reach running time
Output ON signal when the VFD is running and there is
25~30 Reserved
frequency output.
Output ON signal when the VFD is running forward and
there is frequency output.
Output ON signal when the VFD is running reverse and
there is frequency output.
Output ON signal when the VFD is jogging and there is
frequency output.
Output ON signal when the VFD is in fault
Please refer to P08.32 and P08.33 for detailed
information.
Please refer to P08.34 and P08.35 for detailed
information.
Please refer to P08.36 for detailed information.
Output ON signal when the output frequency and given
frequency of the VFD is 0 at the same time.
Output ON signal when the running frequency of the VFD
is the upper limit frequency.
Output ON signal when the running frequency of the VFD
is the lower limit frequency.
When the main circuit and the control circuit are
established and the protection function of the VFD is not
active. The VFD is in the running state and it will output
ON signal.
178
Basic operation instruction
Digital switch-off delay time
P06.07
T delay
P06.09
T delay
P06.11
Delay
T delay
P06.13
T delay
2 In forward running
5 Inverter fault
8 Frequency reached
11 Reach lower limit frequency
Instructions
14 Overload pre-alarm
17 Simple PLC cycle completed
20 External fault reached
MODBUS communication
23
virtual terminal output
Runnin P17.12
g ON/OFF output
terminal
Fault？
P07.38
Fault
present fault
ON/OFF output
terminal state
P06.05, P17.12, P07.38 display
Y BIT0 HDO BIT1
ROI BIT2 RO2 BIT3
0: Open collector high
P06.00 speed pulse output
1: Open collector output