Temperature Sensor Connection At A Sensor Module (Option K50) - Siemens SINAMICS G150 Operating Instructions Manual

Functions, monitoring, and protective functions
9.4 Monitoring and protective functions
Temperature measurement via PT1000
The connection is made to user terminal block (TM31) at terminal X522:7/8. The measured
temperature is limited to between –99 °C up to +188.6 °C and is available for further
evaluation.
● Activating the motor temperature measurement via the external sensor: p0600 = 10
If the customer terminal block TM31 (option G60) is available and after commissioning
has been completed, the source for the external sensor is set to the customer terminal
block (p0603 = {TM31} r4105).
● Set the PT1000 temperature sensor type: p4100 = 6.
9.4.5.3

Temperature sensor connection at a Sensor Module (option K50)

Temperature measurement via KTY
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module in the forward direction of the diode (see corresponding section in chapter "Electrical
installation").
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the KTY temperature sensor type: p0601 = 2.
Temperature measurement via PTC
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module (see corresponding section in chapter "Electrical installation"). The threshold for
changing over to an alarm or fault is 1650 Ω.
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the PTC temperature sensor type: p0601 = 1.
Temperature measurement via PT1000
The device is connected to the appropriate terminals Temp- and Temp+ on the Sensor
Module (see corresponding section in chapter "Electrical installation").
● Activate motor temperature measurement via encoder 1: p0600 = 1.
● Set the PTC temperature sensor type: p0601 = 6.
580
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A