Siemens SINAMICS G150 Operating Instructions Manual page 214

Commissioning
5.3 Procedure for commissioning with STARTER
Selecting a standard motor type from a list
Figure 5-17
⇒ Under Motor name: enter a name for the motor.
⇒ Select a standard motor from the list
⇒ From the selection box next to Motor type:, select the corresponding motor type
⇒ From the list Select motor:, select the corresponding motor
⇒ Under Parallel connection motor, enter the number of motors connected in parallel when
required.
Motors connected in parallel must be of the same type and rating.
⇒ Click on Continue > to configure the motor holding brake
214
Configuring a motor – selecting the motor type, selecting a standard motor from a list
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A