Siemens SINAMICS G150 Operating Instructions Manual page 217

Note
Entering equivalent circuit diagram data
You should only activate the Enter optional equivalent circuit diagram data if the data sheet
with equivalent circuit diagram data is available. If any data is missing, an error message will
be output when the system attempts to load the drive project to the target system.
⇒ Click Continue >
Configuring the motor – Entering optional data
Figure 5-20
⇒ If required, enter the optional motor data.
⇒ Click Continue >
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
Entering optional motor data
5.3 Procedure for commissioning with STARTER
Commissioning
217