Communication Services And Used Port Numbers - Siemens SINAMICS G150 Operating Instructions Manual

• r8854
• p8920[0...239] PN Name of Station
• p8921[0...3]
• p8922[0...3]
• p8923[0...3
• p8924
• p8925
• p8940[0...239] CBE2x Name of Station
• p8941[0...3]
• p8942[0...3]
• p8943[0...3]
• p8944
• p8945
Faults and alarms
• F01910
• A01925
• F08501
• A08526
• A08555
6.13

Communication services and used port numbers

The drive device supports the protocols listed in the following table. The address
parameters, the relevant communication layer as well as the communication role and the
communication direction are specified for each protocol.
This information allows you to match the security measures for the protection of the
automation system to the used protocols (e.g. firewall). As the security measures are limited
to Ethernet and PROFINET networks, no PROFIBUS protocols are listed in the table.
The following table shows the various layers and protocols that are used.
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
6.13 Communication services and used port numbers
COMM BOARD state
PN IP address
PN default gateway
PN Subnet Mask
PN DHCP mode
PN interfaces configuration
CBE2x IP address
CBE2x Default Gateway
CBE2x Subnet Mask
CBE2x DHCP mode
CBE2x interfaces configuration
Fieldbus: Setpoint timeout
Modbus TCP connection interrupted
PN/COMM BOARD: Setpoint timeout
PN/COMM BOARD: No cyclic connection
Modbus TCP commissioning fault
Operation
411