Siemens SINAMICS G150 Operating Instructions Manual page 279

TM31 terminal assignment with "TM31 Terminals" default setting
When you choose the "TM31 Terminals" default setting, the terminal assignment for TM31 is
as follows:
Figure 6-12 TM31 terminal assignment with "TM31 Terminals" default setting
Changing over the command source
The command source can be changed over using the LOCAL/REMOTE key on the AOP30.
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
Operation
6.4 Command sources
279