Siemens SINAMICS G150 Operating Instructions Manual page 216

Commissioning
5.3 Procedure for commissioning with STARTER
Note
Commissioning of an induction motor
The steps described below also apply to commissioning an induction motor.
When commissioning a permanent-magnet synchronous motor, there are a few special
conditions that apply, which are detailed in a separate chapter (see "Setpoint channel and
closed-loop control / permanent-magnet synchronous motors").
⇒ Click Continue >
Configuring the motor – Entering motor data
Figure 5-19
⇒ Enter the motor data (see motor rating plate).
⇒ Activate Enter optional motor data if necessary.
⇒ Activate Enter optional equivalent circuit diagram data if necessary.
216
Configuring the motor – Entering motor data
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A