Siemens SINAMICS G150 Operating Instructions Manual page 565

Parameter
• r0108.14
• r0899
Standstill (zero-speed) monitoring
• r0060
• r0063[0...2]
• p1224[0...3]
• p1225
• p1226
• p1227
• p1228
• p1276
Release/apply brake
• p0855
• p0858
• p1216
• p1217
• p1218[0...1]
• p1219[0...3 ]
• p1220
• p1221
• p1277
• p1279
Brake monitoring functions
• p1222
• p1223
Configuration, control/status words
• p1215
• r1229
• p1275
• p1278
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A
Extended brake control
CO/BO: Status word sequence control
CO: Speed setpoint before the setpoint filter
CO: Speed actual value
BI: Apply motor holding brake at standstill
CI: Standstill detection threshold value
Standstill monitoring speed threshold
Standstill detection monitoring time
Standstill detection delay time
Motor holding brake standstill detection bypass
BI: Unconditionally release holding brake
BI: Unconditionally apply holding brake
Motor holding brake release time
Motor holding brake closing time
BI: Release motor holding brake
BI: Immediately apply motor holding brake
CI: Release motor holding brake, signal source, threshold
Release motor holding brake, threshold
Motor holding brake, delay, braking threshold exceeded
BI: Motor holding brake OR/AND logic operation
BI: Motor holding brake, feedback signal, brake closed
BI: Motor holding brake, feedback signal, brake released
Motor holding brake configuration
CO/BO: Motor holding brake status word
Motor holding brake control word
Motor holding brake type
Functions, monitoring, and protective functions
9.3 Extended functions
565