Tm31 Terminals" Default Setting - Siemens SINAMICS G150 Operating Instructions Manual

Operation
6.4 Command sources
6.4.2

"TM31 terminals" default setting

Preconditions
The customer Terminal Module option (G60) is installed in the cabinet unit.
The "TM31 Terminals" default setting was chosen during commissioning:
• STARTER (p0700):
• AOP30 (p0700):
Command sources
Figure 6-11
Priority
The priority of the command sources is shown in the diagram "Command sources -
AOP30 <-> TM31 terminals".
Note
Emergency OFF signals
The emergency OFF and motor protection signals are always active (regardless of the
command source).
All of the supplementary setpoints are deactivated for LOCAL master control.
278
"TM31 Terminals"
"6: TM31 terminals
Command sources - AOP30 <-> TM31 terminals
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A