Siemens SINAMICS G150 Operating Instructions Manual page 208

Commissioning
5.3 Procedure for commissioning with STARTER
Configuring the drive unit
Figure 5-13
⇒ Under Connection voltage, choose the correct voltage. Under Cooling method: choose the
correct cooling method for your drive unit.
⇒ Under Standard:, choose "IEC" to restrict the selection of drive units offered.
Note
Make a pre-selection
In this step, you make a preliminary selection of the cabinet units. You do not define the line
voltage and cooling method yet.
⇒ A list is now displayed under Drive unit selection:. Choose the corresponding drive unit
according to type (article no.) (see rating plate).
⇒ Click Continue >
208
Configuring the drive unit
Converter cabinet units
Operating Instructions, 07/2016, A5E03347396A