Setting The User Default Parameter Set - Siemens SINAMICS V20 Series Operating Instructions Manual

Commissioning
5.6 Function commissioning
5.6.3.15

Setting the user default parameter set

Functionality
The user default parameter set allows a modified set of defaults, different to the factory
defaults, to be stored. Following a parameter reset these modified default values would be
used. An additional factory reset mode would be required to erase the user defaults and
restore the inverter to factory default parameter set.
Creating the user default parameter set
1. Parameterize the inverter as required.
2. Set P0971 = 21, and the current inverter state is now stored as the user default.
Modifying the user default parameter set
1. Return the inverter to the default state by setting P0010 = 30 and P0970 = 1. The inverter
2. Parameterize the inverter as required.
3. Set P0971 = 21 to store current state as the user default.
Setting parameters
Parameter Function
P0010 Commissioning parameter
P0970 Factory reset
P0971 Transfer data from RAM to EEPROM This parameter transfers values from RAM to EEPROM.
For information about restoring the inverter to factory defaults, refer to Section "Restoring to
defaults (Page 104)".
102
is now in the user default state if configured, else factory default state.
Setting
This parameter filters parameters so that only those related to
a particular functional group are selected. It must be set to 30
in order to store or delete user defaults.
= 30: Factory setting
This parameter resets all parameters to their user default /
factory default values.
= 1: Parameter reset to user defaults if stored else factory
defaults
= 21: Parameter reset to factory defaults deleting user
defaults if stored
= 1: Start transfer
= 21: Start transfer and store parameter changes as user
default values
Operating Instructions, 07/2012, A5E03728167
SINAMICS V20 Inverter