Connectors - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
RUN (LED1)
4 - 22
Table 4-7 CD-CP00 LED Indications (Continued)
LED Indication
LED2 LED3
Blinking Off
Blinking On
Blinking Blinking Blinking Blinking On Steady When
On Off
3.1.5

Connectors

Table 4-8 CD-CP00 Connections
CD-CP00
describes the pin-outs for connectors on the CCPU-A. Refer to
Figure 4-3 CD-CP00 Blade Layout on page 4-14
the connections on the CD-CP00 blade.
Connector
CN1
CN2
CN3
CN4
CN5
CN6/SW2
CN7
CN8/CN9
CN10
SW1
BAT
LED4 LED5
On On On Steady When
USB Memory is
Installing
On On On Steady When
USB Memory is
Installing
USB Memory is
Installing
Off Off
Table 4-9 CD-LTA RJ45 Cable Connector Pin-Outs
,
Table 4-8 CD-CP00 Connections
Backboard Connection
PZ-ME50 (Expanded Memory) Connection
PZ-32IPLA/PZ-64IPLA/PZ-128IPLA Blade Connection
PZ-VM21 Blade Connection
USB Memory Connection (used for upgrading software
or downloading system data)
Used for Debug Purposes
Ethernet Cable Connection (for PCPro or WebPro, CTI,
ACD MIS, IP Phone)
Pin Jack for External Source Connection (External
MOH, External Speaker, etc.)
External Source Control Connection
Load Switch
Lithium Battery Socket (for backup of SRAM memory
data)
UNIVERGE SV8100
Status
Flash memory booting error
Flash memory data error
Reading error of system
program
Off System starting up
describes each connector on the
for the location of
Connector Description
Installing the SV8100 Blades