HEIDENHAIN MANUALplus 620 Technical Manual page 64

Machine
parameters
new/enhanced/
modified
MP Config object
number
100103 CfgHardware
100401 CfgFilter
100402
100403
100404
102307 CfgPlcPath
104701 CfgOemPosition
400013 CfgAxisHardware
400016 CfgAxisHardware
400305 CfgFeedLimits
400501 CfgPositionLimits
400502
64
Enhanced/Modified machine parameters:
Parameter
MP_currentControlAdjust
MP_typeFilter1
MP_orderFilter1
MP_typeFilter2
MP_orderFilter2
MP_compErrorTable
MP_value
MP_inverterInterface
MP_checkPhiFieldRef
MP_maxAcceleration
MP_swLimitSwitchPos
MP_swLimitSwitchNeg
Description of change
The parameter was removed from
the machine configuration.
The parameter was removed since
as of NCK-SW 597 110-05 there are
new MPs for configuration of the
nominal position value filters, see
page 814.
The machine parameter was
removed from the configuration.
The path for the error table of the
PLC compiler has now been
permanently set to
SYS:\config\plccomp.ert by
HEIDENHAIN and cannot be
configured anymore.
The new ACTUAL POSITION
CAPTURE soft key is available for
the parameters for configuring OEM
position values. The soft key
displays a soft-key row showing the
available axes. If you press an axis
soft key, the MANUALplus 620
adopts the position of the axis from
the REFNOML system, see page
1657.
The MP_pwmSignalOutput
parameter was renamed to
MP_inverterInterface, see page
657.
The parameter
MP_checkPhiFieldRef was
removed.
The configurable minimum value
was set to 0.000000001 m/s
The new ACTUAL POSITION
CAPTURE soft key is available for
the parameters for configuring the
software limit switches. The soft
key displays a soft-key row showing
the available axes. If you press an
axis soft key, the MANUALplus 620
adopts the position of the axis from
the REFNOML system, see page
688.
HEIDENHAIN Technical Manual MANUALplus 620
2
.