HEIDENHAIN MANUALplus 620 Technical Manual page 414

Parameter
MP number
iTNC MP number
CfgPosCorrection
Parameters for asynchronous position compensation
enable
100501
(optional parameter)
feed
100502
(optional parameter)
CfgHandwheel
Parameters for configuring the electronic handwheel;
Configuration of serial handwheel connected to X23.
type
100601
MP7640
initValues
100602
MP7645
414
Function and input
Asynchronous position compensation on/off
Input:
on:
Asynchronous position compensation is
switched on
off:
Asynchronous position compensation is
switched off
Velocity for asynchronous position
compensation
Velocity intended for compensations.
Input: 0 to 99 960 [mm/min]
Default: 960 [mm/min]
Type of handwheel
Enter the model of the connected handwheel. If
you set the value HRNAX, you must enter more
details on the connected handwheel in
MP_CfgAxisHandwheel.
Format: Selection menu
Input:
NONE:
No serial handwheel connected
HRNAX:
Up to three HR 150 handwheels via HRA 110
handwheel adapter
HR410:
HR 410 portable handwheel
HR332:
HR 332 portable handwheel
HR330:
HR 330 portable handwheel
HR130:
HR 130 panel-mounted handwheel
Initialization values for handwheel
Format: List [0 to 7]
Input: 0 to 255
Default: 0
HEIDENHAIN Technical Manual MANUALplus 620
Behavior Page
Access
SW vers.
RUN 1253
LEVEL3
RUN 1253
LEVEL3
RUN 1334
LEVEL3
RUN 1334
LEVEL3