HEIDENHAIN MANUALplus 620 Technical Manual page 678

Hide thumbs Also See for MANUALplus 620:

6.6.2 Writing axis information—activating and deactivating axes

This chapter describes how to activate and deactivate axes during operation

and without rebooting the MANUALplus 620, e.g. in order to exchange milling

The MANUALplus 620 has two machine parameters in the CfgAxis

configuration object. They describe the type of connection and the behavior of

MP_axisHw (300104)

MP_axisMode (300105)

For activation and deactivation of axes to be possible at all, the

MP_axisMode parameter has to have the value Active.

With MP_axisMode you specify whether the affected axis is known to the

system (= Active) or not (= NotActive). If axes are not known, there is also no

need for any further parameters. Virtual axes (= Virtual) and axes controlled by

the PLC (= PlcControlled) are ignored in the checks for activating and

deactivating.

With the MP_axisHw parameter you define the hardware type of the axis at

the time of the control startup. For the settings possible, see "MP_axisHw" on

HEIDENHAIN Technical Manual MANUALplus 620