HEIDENHAIN MANUALplus 620 Technical Manual page 625

Specifying the
drive-controller
hardware
January 2012
Settings in the configuration editor
System
CfgHardware
hardwareType
 Specify the type of the drive-controller hardware with the
MP_hardwareType parameter:
MP_hardwareType
Type of drive controller hardware
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: automatic
Automatic identification of controller unit
CC422
CC 422 controller unit for conventional axes
CC424
CC 424 controller unit for direct drives with high control loop
requirements (very short cycle times)
CC61xx
CC 61xx controller unit with HSCI interface
NoCC
No controller unit installed—select this setting for analog
controlled machines (e.g. TNC 320 with MC 320 or
MANUALplus 620 with MC 320T with analog interface to the
drives)
Default: automatic
Access: LEVEL3
Reaction: RESET
6.3 Configuration of Axes
MP number
100101
625