HEIDENHAIN MANUALplus 620 Technical Manual page 452

Parameter
MP number
iTNC MP number
acknowledge
104104
(optional parameter)
toolNumber
104105
(optional parameter)
toolIndex
104106
(optional parameter)
toolMagazine
104107
(optional parameter)
pocketNumber
104108
(optional parameter)
unloadTool
104109
(optional parameter)
452
Function and input
Symbolic name or number of the PLC marker
that is set for acknowledging the strobe
No input:
The strobe is reset with the PLC marker entered
in MP_signal.
Format: String
Input: PLC operand, max. 80 characters
Symbolic name or number of the PLC word for
transmitting the tool number
No input:
The tool number cannot be read as a numerical
value.
Format: String
Input: PLC operand, max. 80 characters
Symbolic name or number of the PLC word for
transmitting the tool index
No input:
The index cannot be read as a numerical value.
Input: String, max. 24 characters
Symbolic name or number of the PLC word for
transmitting the magazine number of the tool
No input:
The magazine number cannot be read as a
numerical value.
Format: String
Input: PLC operand, max. 80 characters
Symbolic name or number of the PLC word for
transmitting the pocket number of the tool
No input:
The pocket number cannot be read as a numerical
value.
Format: String
Input: PLC operand, max. 80 characters
Symbolic name or number of the PLC marker
that is set during decoding if no tool is loaded
The definition of this marker is not necessary, if
the T0 and T1 strobes are otherwise
distinguished.
Format: String
Input: PLC operand, max. 80 characters
HEIDENHAIN Technical Manual MANUALplus 620
Behavior Page
Access
SW vers.
RESET 1577
LEVEL3
RESET 1577
LEVEL3
RESET 1578
LEVEL3
RESET 1578
LEVEL3
RESET 1578
LEVEL3
RESET 1578
LEVEL3
597 110-03