HEIDENHAIN MANUALplus 620 Technical Manual page 729

Settings in the configuration editor
Channels
Kinematics
CfgKinComposModel
K4_CH1_S1 (key name of kinematic model)
subKinList
activeSpindle:
CfgKinSimpleModel
K_XYZ_CH1 (key name of the subkinematics)
kinObjects
CfgKinSimpleAxis
MachAxisX1 (key name of the machine axis)
dir:
axisRef:
MachAxisY (key name of the machine axis)
dir:
axisRef:
MachAxisZ (key name of the machine axis)
dir:
axisRef:
CfgKinAnchor
MACH_BASE (key name of the machine base)
kindOfAnchor:
Channels
ChannelSettings
CH_NC1 (Key name of the machining channel)
CfgActivateKinem
kinemToActivate:
January 2012 6.11 Machine Kinematics (As of NC Software 548328-03)
You must enter the following settings in the configuration editor in order to
configure this three-axis machine. These settings were already performed for
the factory default setting of the NC software.
[0]:
[1]:
[2]:
[0]:
[1]:
[2]:
[3]:
[4]:
[5]:
TOOL_TH1
K_XYZ_CH1
K_WP_S1
S1
TransMaAxDummy2
MachAxisY1
TransMaAxDummy1
MachAxisX1
MachAxisZ1
MACH_BASE
X
X1
Y
Y1
Z
Z1
MachBase
K4_CH1_S1
MP number
K4_CH1_S1.202901.000
K4_CH1_S1.202901.001
K4_CH1_S1.202901.002
K4_CH1_S1.202902
K_ZYX.202800
K_XYZ_CH1.202801.000
K_XYZ_CH1.202801.001
K_XYZ_CH1.202801.002
K_XYZ_CH1.202801.003
K_XYZ_CH1.202801.004
K_XYZ_CH1.202801.005
MachAxisX1.202701
MachAxisX1.202702
MachAxisY1.202701
MachAxisY1.202702
MachAxisZ1.202701
MachAxisZ1.202702
MACH_BASE.203701
CH_NC1.204001
729