HEIDENHAIN MANUALplus 620 Technical Manual page 352

Hide thumbs Also See for MANUALplus 620:

Using update rules

If configuration objects are to be added or deleted during a software update,

then you must define a command for this action in the update rules. You can

call the update rules function to view all previous changes to the

configuration made with update rules.

These rules no longer need to be followed once the software has been

exchanged (see "NC software exchange on the MANUALplus 620" on page

You must save update rules in a file with the extension .cfg.

Ensure that a file with the name PLC:\config\[update rule].cfg exists on

the control.

Enter the Machine Parameters mode of operation, and use the CONFIG FILE

LISTS soft key to enter the path to the [update rule].cfg file as described

Settings under CONFIG FILE LISTS

CfgConfigDataFiles

Edit the [update rule].cfg file with an ASCII editor, such as Notepad or

UltraEdit32. The following pages describe the available commands.

%oemPath%\[update

HEIDENHAIN Technical Manual MANUALplus 620