HEIDENHAIN MANUALplus 620 Technical Manual page 353

January 2012
The following software version-dependent files for the machine
manufacturers' update rules are already available in the directory
PLC:\config\lathe\Manplus:
UpdateOemRel001.cfg
UpdateOemRel002.cfg
UpdateOemRel003.cfg
UpdateOemRel004.cfg
The machine manufacturer is responsible for the update rules specified in
these files. When the control is shipped, the files are empty.
The current OEM update version can be reset with the RESET VERSION soft key
in the configuration editor, in the same way as the HEIDENHAIN update rules.
Always save an [update rule].cfg file in the final configuration of your
machine, and include this file with CONFIG FILE LISTS as described above. This
way you can have this file be overwritten with a new version at any time as
part of a software update, and have the update rules be followed.
4.2 The "Machine Parameters" Mode of Operation
Update rules for software version -01
Update rules for software version -02
Update rules for software version -03
Update rules for software version -04
353