HEIDENHAIN MANUALplus 620 Technical Manual page 590

Parameter
MP number
iTNC MP number
distCarrierRefY
600409
correctionX
600410
correctionZ
600411
correctionY
600412
coorTrafoToModify
600414
590
Function and input
Distance to carrier reference point in Y
Enter the distance between the tool holder
reference point and the tool carrier reference point
in [mm].
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
Compensation in X of the tool-holder position
Enter an X compensation value for the tool holder
position that the control adds to the value from
MP_distCarrierRefX.
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
Compensation in Z of the tool-holder position
Enter a Z compensation value for the tool holder
position that the control adds to the value from
MP_distCarrierRefZ.
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
Compensation in Y of the tool-holder position
Enter a Y compensation value for the tool holder
position that the control adds to the value from
MP_distCarrierRefY.
Format: Numerical value
Input: –100000.000 to 100000.000 [mm]
Default: 0
Coordinate transformations to be modified (up
to NC software 548 328-02)
Enter the key names of the coordinate
transformations that are to be replaced by the
transformations in coorTrafo at the same position
during axis mirroring.
Format: List [0 to 100]
Input: Selection menu
Coordinate transformations off
CfgTrafoByDir
HEIDENHAIN Technical Manual MANUALplus 620
Reaction/ Page
Access
RESET 1402
LEVEL3
RESET 1402
LEVEL3
RESET 1402
LEVEL3
RESET 1402
LEVEL3
RESET 761
LEVEL3