HEIDENHAIN MANUALplus 620 Technical Manual page 416

Parameter
MP number
iTNC MP number
feedFactor
100608
selectAxes
100610
(optional parameter)
crossShortSafety
100609
MP7640
(optional parameter)
416
Function and input
Manual feed rates in the El. Handwheel mode
Percentage factor for the 3 velocity levels. The
effective handwheel feed rate is equal to the feed-
rate percentage factor multiplied by the maximum
handwheel feed rate of the selected axis.
Format: List [0 to 2]
Input:
[0] = First ratio [%]
[1] = Second ratio [%]
[2] = Third ratio [%]
Default: 1, 10 and 100 [%]
Selection of axes for the handwheel
Select the axes to be moved with the handwheel.
Extra information:
On portable handwheels with axis keys,
e.g. HR 410:
Make a list entry for each axis key on the
handwheel. The sequence of the list sets the
assignment to the axis keys X, Y, Z, IV, V on the
handwheel.
With HR 150 panel-mounted handwheels
through HRA 110:
Handwheel on X1 of HRA 110: 1st list entry
Handwheel on X2 of HRA 110: 2nd list entry
Handwheel on X3 of HRA 110: The initialization
parameters and the position of the selection
switch set which list entry is to be used.
With HR 130 panel-mounted handwheel:
Do not define parameter. The axes are assigned
via the PLC program (e.g. Module 9036).
Format: List [0 to 8]
Input: Select the axes using the selection
menu
Cross-circuit-proof handwheel
Specifies whether a cross-circuit test is
performed on the permissive buttons.
Format: Selection menu
Input:
on: Cross-circuit test is active
off: No cross-circuit test
HEIDENHAIN Technical Manual MANUALplus 620
Behavior Page
Access
SW vers.
RUN 1336
LEVEL3
RUN 1338
LEVEL3
RUN/ 1337
LEVEL3