HEIDENHAIN MANUALplus 620 Technical Manual page 586

Parameter
MP number
iTNC MP number
doProgAfterTCall
601806
freezeVconst
601808
ncStartWithActCyc
601809
586
Function and input
Subprogram after tool change
Configure here whether a specific subprogram is to
be executed after the tool change.
Format: Selection menu
Input:
TRUE:
The subprogram _tcall1.ncs is run after the tool
change
FALSE:
No subprogram is run after the tool change
Freezing the spindle speed for rapid traverse
movements and active constant surface speed.
Configure here whether the spindle should change
its speed according to the current diameter at a
constant cutting velocity Vconst and when
performing several rapid-traverse movements.
Format: Selection menu
Input:
TRUE:
The spindle speed is held constant for rapid
traverse movements and active constant surface
speed.
FALSE:
The spindle speed is always adjusted to the
current diameter for rapid traverse movements
and active constant surface speed.
Program run with the most recently selected
cycle
Configure here whether the most recently selected
cycle is to remain active when switching to
Program Run mode.
Format: Selection menu
Input:
On:
When Program Run is selected, the most
recently selected cycle remains active
Off:
When switching to Program Run, the first cycle
of the cycle program is always selected.
HEIDENHAIN Technical Manual MANUALplus 620
Reaction/ Page
Access
RUN 1445
LEVEL1
RUN 1392
LEVEL1
RUN 1417
LEVEL1