HEIDENHAIN MANUALplus 620 Technical Manual page 360

UpdAttributeNew
Value
360
The input value of the indicated machine parameter is checked. If the input
value corresponds to the value entered in the update rule or is within the given
value range...
either the input value is changed or
the input value is multiplied by the given factor and then changed. The
conversion is only effective for numeric parameter values.
If no value range is defined (minValue and maxValue are not set), the new
parameter value is always inserted.
If a single value is entered (minValue or maxValue is set), the new value is
inserted if the old value exactly equals the given value.
This procedure is performed during startup of the control if the version number
of the OEM configuration on the control is older than the version number of
the update rule.
Syntax:
UpdAttributeNewValue (
entity
version
key
attrName
index
minValue
maxValue
value
factor
)
:= STRING, ; Name of the configuration
object
:= REAL, ; Version number
:= STRING, ; Key name, if the value is to be
changed in only one specific
configuration object. Otherwise
do not enter anything.
:= STRING, ; Name of the machine
parameter
:= UNSIGNED, ; Index for list parameters
(OPTIONAL) (arrays). Is only checked if the
parameter is an index
:= STRING, ; Minimum value
(OPTIONAL)
:= STRING, ; Maximum value
(OPTIONAL)
:= STRING ; New input value
(OPTIONAL)
:= REAL ; Multiplication factor
(OPTIONAL)
HEIDENHAIN Technical Manual MANUALplus 620