HEIDENHAIN MANUALplus 620 Technical Manual page 63

January 2012
Enhanced: Search function in the configuration editor
The search function in the configuration editor (Machine parameter
programming mode of operation) was enhancedSee "Finding/Replacing" on
page 339:
• Simultaneous selection of multiple search criteria possible
• If the machine configuration has been searched down to the end or up
to the beginning (depending on the selected search direction) and the
search term has not been found, a new query is displayed. Upon
request the control continues searching in the opposite direction.
New: New behavior when parameters are changed while
NN_GenCycleAfterReConfig (M4174) is set
Changing a machine parameter while the NN_GenCycleAfterReConfig
marker is set leads to a recompilation of the PLC program. Now changes to
such parameters are prevented in any case while the NC program is running.
Therefore, for parameters with the behavior Change at any time
(NOTHING), the behavior PLC/Pgm. run is locked is now displayed to
indicate the changed behavior.
New: Reset system settings
In the configuration editor (Machine parameter mode of operation), the new
RESET SETTINGS soft key in the MORE FUNCTIONS menu can be used to
reset all nonvolatile (= permanent) system settings (See "Resetting system
settings" on page 364).
1.3 NC Software 548 328-04 63