HEIDENHAIN MANUALplus 620 Technical Manual page 145

Hide thumbs Also See for MANUALplus 620:

software update

while the NC

software is running

January 2012

As of SW version 548 328-02 you can undo an NC software update even while

the software is running on the control.

Switch to the Organization operating mode.

Enter the code number 231019.

Press the UPDATE DATA

Then press the LOAD ZIP

Press the PATH soft key to select the directory, in which the setup file is

located, in the left window, e.g. USB0:

Then press the FILES soft key to place the cursor in the right window on file

Press the UNDO UPDATE soft key.

Use the SELECT soft key to select the setup.zip file. The control checks

whether it can use the selected setup file together with the REDO files

saved in the same directory for restoring the previous software level.

Confirm the confirmation request "Do you really want to switch off?". The

NC software is now automatically shut down and then the actual update

program is started.

A dialog field prompts you to select a language.

Confirm the confirmation request "Do you want to continue?".

The next dialog box shows the previous and the currently installed software

version and once again requests a confirmation for uninstalling the software.

After your confirmation, a progress bar appears for the restoration of the

previous software version.

Then confirm the status message announcing the successful restoration of

the software level and remove the USB stick. The control now automatically

2.7 Software