HEIDENHAIN MANUALplus 620 Technical Manual page 497

Parameter
MP number
iTNC MP number
ChannelSettings
Channel-specific settings
[Key name of the machining channel]
Two channels are permanently defined:
CH_NC: Machining channel
CH_SIM: Simulation channel
CfgChannelAxes
Definition of the axes and axis names of this channel
progAxis
200301
refAxis
200303
refAllAxes
200304
(optional parameter)
restoreAxis
200305
(optional parameter)
January 2012
Function and input
Programmable axes
Programmable axis names and axis names for the
position display in the workpiece system.
Format: Array [0 to 8]
Input: Selection of key names from
CfgAxes/axisList
Axes that are to be run over the reference
point
Defines the axes that are to be referenced and the
reference order.
Format: List [0 to 6]
Input: Selection of key names from
CfgAxes/axisList
Homing all axes in succession after an NC
START
Format: Selection menu
Input:
TRUE:
Traverse the reference mark of all axes in
succession after an NC START.
FALSE:
A reference run is not performed for all axes
Default: FALSE
Sequence for returning to the contour
Specifies the sequence in which the axes are
returned to the contour after NC stop or during
block scan. After NC stop, the axes are moved to
the stop position. During a block scan, they are
moved to the calculated restore position.
Format: List [0 to 6]
Input: Selection of key names from
CfgAxes/axisList
4.10 List of Machine Parameters
Reaction/ Page
Access
RESET 618
LEVEL3
RESET 621
LEVEL3
RESET 621
LEVEL3
RESET 623
LEVEL3
497