HEIDENHAIN MANUALplus 620 Technical Manual page 815

Machine parameters in the configuration editor and
recommended input value
System
CfgFilter
defaultPosition
shape:
frequency:
hscMode:
defaultManualOrder:
January 2012
Take the machine setup into account when you configure filters. It is decisive
whether TCPM (Tool Center Point Management, not available on lathes)
executes compensating movements for rotary axes.
Configuration examples
Example 1:
Machine with 3 axes (TCPM is not used)
For a simple 3-axis configuration, the nominal position value filters are globally
defined in CfgFilter: Remove the CfgPositionFilter configuration object from
the parameter sets of the axes. In addition, remove the MP_defaultCutterLoc
parameter since there are no rotary axes and the Cutter Location filter is not
needed.
6.16 The Control Loop
Meaning
Triangle Form of filter: Triangle filter
24 Limit frequency: 24 Hz
Smoothing HSC mode: Finishing
11 Filter order in Manual operating
modes: 11
815