HEIDENHAIN MANUALplus 620 Technical Manual page 136

2.7.4 Configurations
136
The maximum configuration of the MANUALplus 620 is designed for one slide
(with X, Z, Y, U, V and W axis), main spindle, opposing spindle, C1/C2 axis and
driven tool. Use parameters to hide components not present on the machine.
You also set the type of C-axis drive (separate C-axis drive or driven with
spindle motor) via parameter. If there is a separate drive for the C axis, an
additional control loop is required.
Please contact HEIDENHAIN if you require a different configuration.
Configuration of MANUALplus 620
Machine setup
U
Note
Please note that, if the same position encoder is used for the main spindle
and the C axis, the operation of a separately driven C axis along with the
use of a CC 61xx is not possible until the beginning of 2012. Contact
HEIDENHAIN if you need this feature before the above mentioned date.
Axes and spindles
Example 1:
2 spindles (spindle and driven
tool)
1 slide
2 linear axes (X1 and Z1 axes)
C1 axis (drive with spindle motor)
Example 2:
2 spindles (spindle and driven
tool)
1 slide
4 linearaxes (X1, Z1,Y1 and W1
axes)
C1 axis
V
Example 3:
3 spindles (spindle and opposing
spindle, driven tool)
1 slide
3 linear axes (X1, Z1 and W axes)
C1/C2 axis
W
HEIDENHAIN Technical Manual MANUALplus 620