HEIDENHAIN MANUALplus 620 Technical Manual page 423

Parameter
MP number
iTNC MP number
shutdownOnOem
101604
MP4040
maxTermTime
101605
(optional parameter)
powerOffDevice
101608
(optional parameter)
powerOffSlot
101609
(optional parameter)
January 2012
Function and input
Behavior when PLC module 9279 is called
Specifies the MANUALplus 620's behavior when
the OEM shuts down the control using PLC
module 9279.
Format: Selection menu
Input: see MP_shutdownOnConfig
Default: TERMINATE
Delay time until control is shut down
Defines the time before the process is
terminated.
Format: Numerical value
Input: 0 to 1000 [s]
Default: 0 [s]
Number of the device in the HSCI chain
System with HSCI interface:
Enter the number of the device in the HSCI chain
(= bus address) at which the control is to set a
PLC output after shutting down in order to switch
off the power supply, for example.
System without HSCI interface:
Do not assign the parameter.
Format: Numerical value
Input: 0 to 20
Default: 0
Number of the PL module in the HSCI device
System with HSCI interface:
Enter the number of the PL module on the HSCI
PL at which a PLC output is to be set after
shutting down.
System without HSCI interface:
Do not assign the parameter.
Format: Numerical value
Input: 0 to 8
Default: 0
4.10 List of Machine Parameters
Behavior Page
Access
SW vers.
PLC/Pgm 1321
run is
locked
LEVEL1
PLC/Pgm 1322
run is
locked
LEVEL1
PLC/Pgm 1322
run is
locked
LEVEL1
PLC/Pgm 1322
run is
locked
LEVEL1
423