HEIDENHAIN MANUALplus 620 Technical Manual page 532

Parameter
MP number
iTNC MP number
encoderResistor
400208
(optional parameter)
decToSoftLimit
400209
(optional parameter)
CfgFeedLimits
Define the axis velocities and acceleration;
For rotary axes and spindles, the velocity is specified in [°/min] and the acceleration in
2
[1000°/s ].
minFeed
400301
MP3240.1
maxFeed
400302
MP1010,
MP3515
rapidFeed
400303
MP1010
532
Function and input
Terminating resistor of position-encoder input
for handwheel
Format: Selection menu
Input:
without:
Without terminating resistor
120 ohms:
With terminating resistor
Default: without
Braking ramp for handwheel movement to
software limit switch
(MP_swLimitSwitchPos or
MP_swLimitSwitchNeg)
Format: Numerical value
Input: Braking ramp [m/s
2
[1000°/s ] for rotary axes
Default: 0
Applies only to the main spindle: minimum
spindle speed
Format: Numerical value
Input: 0.0 to 36 000 000.0 [°/min]
Default: 0 [°/min]
Maximum axis feed rate (rapid traverse) or
maximum spindle speed
Format: Numerical value
Input: 0.0 to 36 000 000.0 [mm/min] or
[°/min]
Default: 16 000.2 [mm/min] or [°/min]
Rapid traverse in manual mode
Maximum axis feed rate in manual mode, using
the rapid traverse key. For rotary axes and
spindles, the velocity is specified in [°/min].
Format: Numerical value
Input: 0.0 to 36 000 000.0 [mm/min] or
[°/min]
Default: 4 999.98 [mm/min]
HEIDENHAIN Technical Manual MANUALplus 620
Reaction/
Access
PLC/Pgm
run is
locked
LEVEL3
PLC/Pgm
run is
locked
LEVEL3
597 110-03
2
] or
Allowed in
strobe
LEVEL3
Allowed in
strobe
LEVEL3
Allowed in
strobe
LEVEL3
Page
1341
1343
831
831
832