Output Specifications - Simrad GC80 Dual MK2 User Manual

Simrad GC80/85 Dual MK2 Gyro Compass
8.4

Output specifications

When Gyro is
selected
Note!
When External
heading sensor is
selected
988-12720-002
Serial output signal 1
Circuits: ....................................................................................................... 10
Electrical: ................................................................................... RS422/485
Baud rate:
GC80: ........................................................................ 4800/38400 bps
GC85: .................................................................................... 38400 bps
Baud Rate for GC85, refer
signal selection, page 119.
Data bits: .............................................................................................. 8 bits
Parity: ..................................................................................................... None
Stop bits: ...................................................................................................... 1
Transmit freq.:
GC80: ............................................................................. 1, 5, 10, 50 Hz
GC85: ............................................................................. 1, 5, 10, 50 Hz
Output format:
Data no.1
$--HEHDT,xxx.x,T*hh<CR><LF>
Data no.2
$--HETHS,xxx.x,a*hh<CR><LF>
Data no.3
$--HEROT,-xxx.x,a*hh<CR><LF>
Data no.5
$--PTKM,HEALM,xxxx,x,xx*hh<CR><LF>
Serial output signal 2 *1
Circuits: ....................................................................................................... 10
Electrical: ................................................................................... RS422/485
Baud rate:
GC80: ...................................................................................... 4800 bps
GC85: .................................................................................... 38400 bps
Data bits: .............................................................................................. 8 bits
Parity: ..................................................................................................... None
Stop bits: ...................................................................................................... 1
Transmit freq.:
GC80: ............................................................................. 1, 5, 10, 50 Hz
GC85: ............................................................................. 1, 5, 10, 50 Hz
Output format:
Data no.1
$--HDT,xxx.x,T*hh<CR><LF>
Data no.2
$--THS,xxx.x,a*hh<CR><LF>
Data no.3
$--HDG,xxx.x,xx.x,a,xx.x,a*hh<CR><LF>
Data no.4
$--ROT,-xxx.x,a*hh<CR><LF>
Jumper settings on SCC boards
, output serial
82