Removing The Tray A Unit; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Stacking Assembly > Removing the Tray A Unit > Procedure

Removing the Tray A Unit

■ Preparation

1) Remove the Stack Wall (Upper).(Refer to page 4-27)
2) Remove the Neat Stack Unit (Upper).(Refer to page 4-57)
3) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
4) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Remove the Inner Cover (Upper).(Refer to page 4-22)

■ Procedure

CAUTION:
When replacing or installing/removing the Tray A, be sure to perform the following
adjustment.
• Adjusting the Positions of the Tray A and B (Refer to page 4-37)
1) Remove the Support Column Cover [1].
• 1 Claw [2]
[1]
[2]
4 Parts Replacing and Cleaning > Stacking Assembly > Removing the Tray A Unit > Procedure
2) Remove the Tray A Upper Limit Stopper [1].
• 1 Screw [2]
3) Free the harness [1].
• 1 Reuse Band [2]
• 1 Wire Saddle [3]
• 2 Edge Saddles [4]
• 4 Connectors [5]
F-4-52
[1]
[2]
x4
[5]
[4]
4-32
F-4-53
[4]
[3]
[2]
[1]
F-4-54
4-32