Removing The Push-On Plate; Preparation; Procedure - Canon Booklet Finisher-D1 Service Manual

4
Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Push-on Plate > Procedure

Removing the Push-on Plate

■ Preparation

1) Open the Front Cover.
2) Pull out the Saddle Unit.
3) Remove the Saddle Inner Cover (Lower).(Refer to page 4-89)
4) Remove the Thrust Unit.(Refer to page 4-95)

■ Procedure

1) Turn the gear [1] in the direction of the arrow so that the Thrust Plate [2] is at the most-
protruded position [A].
[A]
[2]
4 Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Push-on Plate > Procedure
[1]
F-4-234
2) Be sure to mark the current 2 positions [1] of the Thrust Plate (where the engraved marking
and the outer line of the Thrust Plate are overlapped).
[1]
3) Remove the Thrust Plate [1].
• 3 Screws [2]
• 1 Thrust Plate Fixation Plate [3]
[1]
[2]
4) When installing a new Thrust Plate, secure it by fitting with the marked positions in step 2.
4-97
[1]
F-4-235
[3]
F-4-236
4-97