Table of Contents
Advertisement
5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Alignment Position of the Upper Neat Alignment Plate > Procedure
Adjusting the Alignment Position of the Upper Neat
Alignment Plate
Execute the adjustment in the following cases.
• When replacing or installing/removing the Neat Stack Unit (Upper) and the component
parts of the unit
• When replacing the Finisher Controller PCB
Adjusting method is as follows:
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
■ Procedure
1) Set DIP SW382 [1] on the Switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Alignment Position of the Upper Neat Alignment Plate > Procedure
ENTER
F-5-31
2) Press the Push Switch SW385 [1] to complete preparation for the adjustment.
SW382
SW381
SW383
SW384 SW385
(-)
(+)
3) Place A4 or LTR size paper in the ADF.
4) Press the Start key on the Control Panel to start copy.
5) By pressing the Push Switch SW383 [1] or SW384 [2], the adjustment amount is
determined, and the adjustment value is displayed on LED [3].
By pressing the SW383 [1], the Front Neat Alignment Plate [4] moves toward the front by
approx. 0.2 mm. On the other hand, by pressing the SW384 [2], the Front Neat Alignment
Plate [4] moves toward the rear by approx. 0.2 mm. Adjust the distance between the paper
edge (front side) [A] stopped at the Top Delivery Outlet and the Front Neat Alignment Plate
[4].
• Adjustment range: +15 to -15 (shift amount per unit: 0.2 mm)
[3]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[1]
[2]
ENTER
[1]
F-5-32
[4]
[A]
5-17
F-5-33
5-17
Advertisement
Table of Contents
